Initialize Tab; Factory Default; Backup Setting Data - Sony IPELA SNC-P1 User Manual

Date & time format
Select the format of date and time to be displayed on the
main viewer from the drop-down list.
You can select from among yyyy-mm-dd hh:mm:ss
(year-month-day hour:minute:second), mm-dd-yyyy
hh:mm:ss (month-day-year hour:minute:second), and
dd-mm-yyyy hh:mm:ss (day-month-year
hour:minute:second).
Adjust
Select to set the day and time.
Keep current setting: Select if you do not need to set
the date and time.
Synchronize with PC: Select if synchronizing the
camera's date and time with those of the computer.
Manual setting: Select if you want to set the camera's
date and time manually.
Select the lower 2-digits of year, month, date, hour,
minutes and seconds from each drop-down list.
Synchronize with NTP: Select if synchronizing the
camera's date and time with those of the time sever
called NTP server (Network Time Protocol). Set the
NTP server name and the Interval.
NTP server name
Type the host name or IP address of the NTP server, up
to 64 characters.
Interval
Select the interval at which you want to adjust the
camera's time referring to the NTP server' time, between
1 and 24 hours. The set interval is a guide, and does not
indicate the exact time.
Note
The setting time may not accord with the exact time
according to the network environment.
Time zone
Set the time difference from Greenwich Mean Time in
the area where the camera is installed.
Select the time zone where the camera is installed from
the drop-down list.
Automatically adjust clock for daylight saving
time changes
When you select it, the clock is automatically adjusted
according to the daylight saving time of the selected
time zone.
Note
If the time zone selected on the Time zone menu is
different from that set on the computer, the time is
adjusted using the time zone difference and set on the
camera.
32
Configuring the System — System setting menu
OK/Cancel
See "Buttons common to every setting menu" on page
29.

Initialize Tab

Reboot
Reboots the camera.
Click Reboot, and the message "The SNC-P1 will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to start again.

Factory default

Resets the camera to the factory settings.
Click Factory default, and the message "Set up data
will be initialized. Are you sure?" appears. When you
click OK, the network indicator and the Blue LED on
the camera start to blink. After adjustments of the
default settings have finished, the camera reboots
automatically. Do not turn off the camera until the
camera reboots.
Tip
The camera can also be reset to the factory settings by
turning the power on of this unit while pressing the reset
switch on the camera. For details, see the supplied
Installation Manual.

Backup setting data

Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web
browser to specify the folder and save the setting data of
the camera. The file name preset at the factory is "snc-
p1.cfg."
Restore setting
Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data
is stored. Then, click OK, and the camera is adjusted
according to the loaded data and restarted.