Seat PLUS/NAVI SYSTEM Owner's Manual page 19

18 Audio mode
Browsing the fre- Place your finger on the slider in the frequency dial and
quency band drag it along the dial.
quickly
Hiding the fre- Briefly press the function button
quency band If you select a station with a stored station button, the
manual selection of the frequency is also finalised. If
you do not do anything else, after a certain time the fre-
quency band will close automatically.
Storing stations
Storing the sta- Hold down the desired stored station button
tion that you are until you hear the signal. The station that you are listen-
listening to in ing to will be stored in this button.
one of the stored
station buttons
Storing a station Press the function button
from the list of list of stations.
stations in one of The stations already assigned to stored station buttons
the stored station are shown in the list of stations marked with the sym-
⇒ F ig.
buttons bol 
Select the desired station holding it down on the dis-
play until the screen for storing stations appears.
Press the stored station button where you wish to save
the station. A signal will sound and the station will then
be saved in this stored station button. The system auto-
matically returns to the list.
Deleting a stored In the menu
station setup you can delete the stored stations one by one or
all at once ⇒ p age 20.
Scan function (SCAN)
When the scan function is running, all available stations on the current fre-
quency band are played in sequence for around 5 seconds each.
.
Manual
⇒ F ig. 12
⇒ F ig. 12
to open the
Stations
13.
Delete presets , available in the menu
Starting the scan Briefly press the setup button.
function OR: Press the function button
Stopping the scan Press the function button
function stop the scan function on the station you are listen-
ing to.
OR: Briefly press the setup button.
The scan function also ends when you manually se-
lect a station using the stored station buttons, or
when a traffic report comes in.
Autostore (automatic station storing)
Hold the RADIO button down for approximately 10 seconds to carry out the
autostore function for the stations that can be tuned in at the time of run-
ning the Autostore. The stations are saved in the stored station buttons.
Note
This function can take several minutes, during which time the radio will re-
main muted. In addition, any stored stations assigned previously will be de-
leted.
Radio

Setup
.
SCAN
"crossed out" to
SCAN
and then select

