Re-Supplying Water To The Unit; Troubleshooting - Toto Washlet C110 SW524 Instruction Manual

Drain the water from inside of
the Washlet main unit by pulling
the Washlet removal button (and
the water drain lever).
• Water flows out from the side of the nozzle.
Drain the water into the toilet bowl. It takes
about three minutes to drain the water
completely.
Put the Washlet removal button (and the water drain
lever) back in place.
Reattach the Washlet
main unit.
➀ Align the center of the Washlet main unit with that of
the base plate.
➁ Slide the Washlet main unit along the toilet bowl
surface and push it in securely until you hear it click.
✲
The Washlet will not work unless the Washlet main
unit is securely pushed into the base plate.
Pour antifreeze liquid into the toilet bowl.
Re-supplying Water To the Unit After the Pipes Have Been Drained
Open up the water shut off
valve and the junction valve.
• Open the junction valve with a flathead screwdriver.
Confirm that no water is leaking from the Washlet
main unit or houses.
Insert the power supply plug into the wall outlet.
Let the water flow out from the nozzle.
• Cover the seat sensor with a piece of white paper and let the
water flow out from the nozzle for about two minutes by
pressing .
(It takes about one minute to discharge the water from the
nozzle. Collect the discharged water in a paper cup, etc.)
1
If no water flows out because the remaining water froze, warm the inside of the toilet and also warm the
supply hose and the water shutoff valve using a cloth soaked in hot water.
26
You can not pull the drain
lever without detaching
the Washlet main unit.
Washlet removal button
(and the water drain lever)
ase plate
Push in until you Push in until you
feel a ÒclickÓ. feel a ÒclickÓ.
1

Troubleshooting

Please check the following before calling for service.
If that doesn't solve the problem, please call TOTO U.S.A., Inc. Technical Support at (888) 295-8134
General
Problem Check (Cause)
Is there a power outage or is the circuit
breaker out?
Are all of the LEDs on Washlet main unit
Doesn't work at all.
operation panel out?
Is the Washlet main unit lined up properly
with the base plate?
Rear Cleansing / Front Cleansing
Problem Check (Cause)
Has water stopped flowing from the main
supply?
Are the water shut off valve and the junction
valve closed?
Water will not spray.
Is the seat sensor working properly?
Is the Washlet main unit lined up properly
with the base plate?
Is the water pressure setting set too low?
The water pressure is
low.
Is the water filter with drain valve dirty?
Is the water temperature setting button OFF
or set too low?
The cleansing water
is too cold.
Is the timer energy saver activated?
Response
Wait until the power is restored. Turn the
circuit breaker back ON.
Push the button on the Washlet main
unit operation panel. Page 10
Detach the Washlet main unit from the
base plate and reinstall. Page 20
Response
Push the button and wait until the
main water supply is restored.
Open the water shutoff valve and the
junction valve. Page 10
Change the way you sit and / or hold your
arms near the seat sensor.
Detach the Washlet main unit from the
base plate and reinstall. Page 20
Push the water pressure adjustment
button on the Washlet main unit
operational panel. Page 11
Clean the water filter with drain valve.
Page 22
Adjust the water temperature by pushing
the high. Page 12
Sit on the toilet seat and wait for about 10
minutes.
27