Care And Cleaning; Replacing The Fill Valve; Adjusting The Water Level - Toto CST436 Installation And Owner's Manual

Dual-flush toilet

Hide thumbs Also See for CST436:

Installation and owner's manual (32 pages)

Table Of Contents

Table of Contents

Use a detergent or non-abrasive toilet cleaner and a soft bristled

plastic brush to clean your toilet. To remove hard water stains, use

vinegar or lime dissolving cleaner and a non-scratch scour pad made

for porcelain. Allow a little contact time to allow the cleaner to dis-

solve the buildup.

NOTICE

DO NOT USE IN-TANK BOWL CLEANERS.

The use of high concentration of chlorine or chlorine-related products can

failure or damage caused by the use of in-tank bowl cleaners.

1. Shut off the water supply. Flush the toilet and

remove any remaining water from the tank. Reverse

the tank installation instructions to remove it from

of the shaft through the hole in the bottom of tank.

3. Thread mounting nut onto exposed shaft under the

CAUTION

Do not over-tighten.

4. Connect the water supply (Ill. 1). Pipe dope is not recommended. Attach

Refer to the water level line stamp inside the tank.

1. The water level adjustment is located in the top

make adjustments:

•

To raise the water level: turn the screwdriver

clockwise, or towards the '+' indicator.

•

To lower the water level: turn the screwdriver

counter-clockwise, or towards the '-'

indicator.

2. Flush after each adjustment to check the water

once more to verify.