When Not Using The Washlet Over An Extended Period Of Time; Re-Supplying Water To The Unit After The Pipes Have Been Drained - Toto Washlet E200 Series Instruction Manual

Set the toilet seat temperature to
"High".
➀ Check to make sure the Power ON/OFF
button is ON and set the toilet seat
temperature to "High" using the remote
controller.
➁ Lower the toilet seat cover.

When not using the Washlet over an extended period of time:

● Water left standing in the toilet hoses over an extended period time can cause irritation to the
skin. Also, in order to eliminate the risk of frozen pipes, drain the pipes of water.
Draining the pipes.
Drain the water out of the toilet tank.
(Refer to No.1, Page 28)
Drain the water out of the pipes.
(Refer to No.2, Page 28-29)
Pull the drain plug out to drain water
from the main unit.
● Remove cover with flat head screwdriver.
● Loosen the drain plug with a flat head
screwdriver and pull it out.
● Water (approximately 24 ounces (700 ml)) will
drain from the outlet.
Reinsert the drain plug.
1 ■ When the product is not in use during winter months.
■ For products installed at a seasonal home or lake cabin.
● Be sure to drain the water pipes when the product is not in use during the cold winter months.
Always drain the water pipes when the product is not in use over an extended period of time to prevent
frozen pipes.
30
Main unit display Remote controller
Power light
Flathead screwdriver
Drain plug
Turn to the left
Reinstall the water filter with drain
valve.
(Refer to No.3, Page 29)
Remove the electrical plug from the
wall outlet.
Pour antifreeze into the toilet bowl.

Re-supplying water to the unit after the pipes have been drained:

1
Open the water shutoff valve and the
junction valve with the flat head
screwdriver.
● Check to make sure that water does not leak
from the pipe or main unit.
Plug the electrical plug into the wall
outlet.
Spray water from the wand.
● Cover the toilet seat sensor with white paper and push the "Rear Cleansing" or "Front Cleansing" button
to activate a spray of water from the wand. (Receive the water with a paper cup, etc.)
Pour antifreeze into the water remaining in the toilet bowl to provide even greater protection against frozen
2
water pipes.
3 If the residual water freezes:
● If the residual water in the water hose or water shutoff valve freezes, warm the room temperature of the
bathroom and wrap a cloth wet with warm water around the water hose and shutoff valve.
2
Turn
counter-clockwise
Turn counter-
clockwise
3
31