Pump & Brush Belts Replacement - Bissell POWERWASH 1694 User Manual

Pump & Brush Belts Replacement
To Remove Broken Pump & Brush Belts
Turn off machine and unplug from wall outlet.
1.
Step on Handle Release pedal and recline handle
2.
on floor (see illustration).
Remove the Tank-in-Tank. Set aside
3.
(see illustration).
Remove the Belt Access Door located near the
4.
ReadyTools Dial. Insert a flathead screwdriver into
the slot nearest the handle to gently pry off the
door (see illustration).
Turn the machine onto its side so the belt access
5.
area is facing upward (see illustrations)
On the bottom of the machine, near the belt
6.
access area, is a red retainer plate that holds the
black brush arm and brush in place. Using a
Phillips head screwdriver remove the screw that
holds the red retainer plate in place. Set red
retainer plate and Phillips head screw aside
(see illustrations).
Remove the black brush arm that holds the brush
7.
in place. Set the black brush arm aside
(see illustrations).
Remove the "toothed" brush belt from the brush
8.
then from the red pump pulley. Set the "toothed"
brush belt and brush aside.
Locate and remove the broken pump belt.
9.
7
8
2
3
4
5
Red Retainer
6
Plate
9
15