Table of Contents
Advertisement
M
aintenance and care
Brush removal and
replacement
1. Turn OFF (0) the machine and unplug
from the outlet.
2. Remove the dirty and clean water tanks
from the base of the machine.
3. While standing behind the unit, lay the
unit on its' side (cord side down).
4. Looking at the bottom of the unit, find the
center of the brush carriage where the
carriage latch is located. It is between
the brush assembly and wheels.
5. Pull the brush carriage towards you with
one hand until it stops. Pinch the car-
riage latch with the other hand while
pulling the carriage towards you. The
carriage should swing out to access
brush end cover.
6. Remove three screws from endcap. Pull
endcap off to release brush roll.
14
www.bissell.com.au
WARNING:
To reduce the risk of fire, electric
shock, or injury,turn power
OFF and disconnect plug from
electrical outlet before performing
maintenance or troubleshooting.
3.
4.
6A.
1.800.811.183 / 0800.247.735
5.
6B.
Advertisement
Table of Contents
