5. Wiring Design
5-2-2. Cable Connections
1. Schematic Diagram of a Unit and Terminal Block Arrangement
To remove the front panel of the control box, unscrew the four screws and pull the panel forward and then down.
Power supply
terminal block
Cable strap
Important: Power supply cables larger than 25 mm
(TB2). Use a pull box to connect them.
2. Installing the conduit tube
Punch out the knockout hole for wire routing at the bottom of the front panel
with a hammer.
When putting wires through knockout holes without protecting them with a
conduit tube, deburr the holes and protect the wires with protective tape.
If damage from animals is a concern, use a conduit tube to narrow the
opening.
MEES19K001
Cable strap
Power wire
Transmission cable
2
in diameter are not connectable to the power supply terminal block
Control terminal block
Power wire
Fix in place with a cable tie.
Knockout hole
Transmission cable
Burr
42