Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for BE P2014EN
Summary of Contents for BE P2014EN
- Page 1 ELECTRIC PRESSURE WASHER P2014EN Operation Manual 94237-DM...
-
Page 2: Table Of Contents
(lbs/sq. in.) (Gal/per min) Water Volts Amps (lbs.) Extension Lance Screw Wheels P2014EN 2050 ü 36.4 Cotter Pin *Packaged on the power washer unit. HARDWARE CONTENTS This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. -
Page 3: Safety Information
Due to the high pressure involved, it CAUTION controls. spraying stops for a moment. cannot be repaired if cut or damaged. Potential hazard that may result 8. This power washer conforms to 16. The power washer is equipped with 24. Only use detergent specifically... - Page 4 Appliance the system, and should only be done by 34. NEVER use lances or other parts that damaged and become inoperable. Or, if qualified service personnel.
-
Page 5: Assembly Instructions
PREPARATION PREPARATION Before beginning assembly of product, Estimated Assembly Time: 5 minutes make sure all parts are present. Compare parts with package contents list and Tools Required for Assembly (not hardware contents list. If any part is included): Phillips screwdriver missing or damaged, DO NOT attempt to assemble the product. - Page 6 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Extension Lance installation While spray gun (K) is in the locked position, insert lance (*I) into the end of spray gun by inserting and turning clockwise until fully in place. To remove, turn counterclockwise. Unlocked Locked Slide spray gun holster (M) into place on the upper handle (B).
- Page 7 • Make sure the power switch is off • Release the spray gun trigger to into power washer unit by slightly pull- (light will be off). stop the power washer. ing on hose. The hose is now securely • Unwind the power cord completely •...
-
Page 8: Operating Instructions
The power cord then can be slid off • When using detergent (not included), concentration. non-water soluble grease such as to either side of the power washer unit. -
Page 9: Care And Maintenance
The cleaning solution should adapter. • DO NOT store the power washer where be the consistency of water in order to it is exposed to freezing temperatures prevent clogging your detergent bottle unless you use an antifreeze designed and nozzle. -
Page 10: Pump Saver
You may cut away the end of the sleeve spray gun. Is this a with a sharp knife if unable to move the sleeve down. Be careful not to cut or for your power to prevent staining, Bottle are generic and not model puncture the hose. -
Page 11: Replacement Parts List
0° – Red Warranty Process 15° – Yellow To place a warranty claim, go to the support section of BE’s website at bepowerequipment.com and fill out the online form with the following information: 25° – Green 1. Dealer Information (Contact name and number) 2. - Page 13 POWER EQUIPMENT If you need assistance with the assembly or operation of this Electric Pressure Washer please call 1-866-850-6662...
Need help?
Do you have a question about the P2014EN and is the answer not in the manual?
Questions and answers