Table of Contents
Advertisement
Output Voltage LED
This LED shows the voltage level at the V OUT terminal.
It becomes the battery voltage when there is no Load connected to the battery and no input voltage.
LED status
Fast Flashes
Slow Flashes
Solid
Battery Type Selection
1.
Press and hold the only Set Button for about 5 seconds until the LED flashes.
2.
Quick presses will move the LED in cyclic order from Lead--> AGM--> LFP-->Type2 + Lead --> Type2 +
AGM --> Type2 + LFP --> Lead-->AGM-->LFP....
3.
Stop at the chosen battery type and wait till LED turns to solid to lock in your selection.
Connections
Allow 10 seconds delay time after connections are done correctly with proper input & output voltage for
selected charge control.
Fig.3 Terminals & 8 PIN connectors
1
T+:
2
Red:
3
Green:
4
Yellow:
5
Alarm:
6
GND:
7
Ignition:
8
Vout for Ignition:
Battery Voltage Level
Battery Voltage lower than 12.5V
Battery Voltage between 12.5V and 13.6V
Battery Voltage higher than 13.6V
Vibration sensor enable pin. Connect to Vout for Ignition pin to enable Vibration
sensor control.
Connection to remote module Red wire.
Connect to remote module green wire.
Connect to remote module yellow wire.
Alarm output pin. 12V 50mA for external alarm.
Ground pin for remote module. Connect to remote control black wire.
Connect this pin to ignition car ignition to make the charger operate in sync with
vehicle ignition control.
12 Voltage signal.
Short this pin to pin 7 (Ignition) to enable manual ignition control of unit to ON.
Short this pin to Pin1( T+ ) to enable vibration sensor mode.
*This pin is for Ignition and Vibration sensor only. Don't connect to other devices.
.
Advertisement
Table of Contents
