Descaling - Krups AUTOMATIC XP52 Series Manual

CLEANING OF THE STEAM NOZZLE
n This accessory consists of 2 parts: one part which is the plastic support and the other which is the
metal protection cylinder.
n Before cleaning, unlock the nozzle from the articulated arm by turning it to the left. (fig.16, 16.2)
n Then slide the metal cylinder along the plastic support (fig.16.3).
n Clean these two parts with tap water and some mild washing-up liquid (fig.17).
n Rinse and dry.
n Once the parts have been properly cleaned, put the metal cylinder back on the support.
n Make sure that you don't damage the silicone seal which makes the nozzle watertight (fig.16.3).
n Insert the nozzle on the articulated arm then lock to the right (fig.18.1, 18.2).
CLEANING OF THE AUTO-CAPPUCCINO ACCESSORY
n For more thorough cleaning, the filter holder can be dismantled into 4 separate parts.
n Use water and a little gentle washing-up liquid and a small brush. Rinse it and dry it and then put it back
together.
n Note the direction in which the tube in inserted (fig.24).

8. DESCALING

The warranty does not cover machines which have become faulty because descaling was not periodically
performed.
Descale your espresso machine regularly using , available from Krups authorized service centers.
In addition to two packets of descaling powder, the kit also includes a water hardness tester to help you
determine the proper schedule for descaling your machine in normal use. The amount of scale that
develops depends on the hardness of the water used, but also the level of use. The schedule indicated
by the water hardness tester is a general guideline only. Keep in mind that you may have to descale more
frequently than indicated.
Ave. number
coffees per week
Less than 7
From 7 to 20
Over 20
DESCALING THE MACHINE
n Empty the tank and replace.
n If you are using a Claris cartridge (model F088) in your water tank, remove the cartridge before
descaling.
n Follow the instructions for using the Krups descaling powder inside the kit.
n Then insert the filter holder (without espresso grounds) and lock into place by turning to the right. Place
a container under the steam nozzle to catch the water.
n Press the "on/off" button to turn the machine on. During the pre-heating phase, the indicator light will
flash. Once it stops blinking, turn the knob to the "steam" position (fig.13) and let 3.4 oz of this mixture
drain flow through (the equivalent of a mug) and then turn the knob back to the "0" position (fig.15).
n Place a container of sufficient volume under the filter holder.
n Once the light stops flashing, press the "2 cups" button and let the water flow through before repeating.
n Turn the appliance off by pressing the "On / Off" button immediately after this second cycle.
DESCALING FREQUENCY
Soft water
(<19°th)
Once a year
Every 4 months
Every 3 months
If in doubt, it is recommended to descale every month.
Hard water Very hard water
(19-30°th)
Every 8 months Every 6 months
Every 3 months Every 2 months
Every 2 months Every month
English
(>30°th)
10