Projecting - Sony VPL-ES3 Operating Instructions Manual

To connect to a video GBR/
Component output connector
Rear side
S VIDEO VIDEO
to to
audio audio
output output
(L) (R)
1 Signal Cable (not supplied)
HD D-sub 15-pin (male) ↔ 3 × phono jack
2 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
Notes
• For stereo audio connection, connect the
stereo audio connecting cable to the AUDIO
connector for VPL-ES3, or to the AUDIO
INPUT A/B connector for VPL-EX3.
• Set the aspect ratio using "Wide Mode" on
the INPUT SETTING menu according to the
input signal.
• When you connect the projector to a video
GBR output connector, select "Video GBR"
or when you connect the projector to a
component output connector, select
"Component" with the "Input-A Signal Sel."
setting on the SET SETTING menu.
• Use the composite sync signal when you
input the external sync signal from video
GBR/component equipment.
16

Projecting

INPUT
AUDIO
INPUT A INP
AUDIO INPUT A/B
to video
GBR/
component
output
VCR
Projecting
ON/STANDBY indicator
Rear
remote
control
detector
APA INPUT
KEY
STONE
ENTER
RESET MENU
PIC
MUTING
D ZOOM VOLUME
FREEZE
1
Plug the AC power cord into a wall
outlet, and connect all equipment, then
remove the lens cover.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2
Press the ?/1 key.
The ON/STANDBY indicator lights
after flashing in green. The projector
cannot be used while the ON/
STANDBY indicator is flashing.
3
Turn on the equipment connected to
the projector.