Messages List - Sony VPL-CX86 Operating Instructions Manual

Messages List

Warning Messages
Use the list below to check the meaning of the messages displayed on the screen.
Message
High temp.!
Probably use in high
altitude. Switch to high
altitude mode on? Yes V
No v
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the Lamp.
Please clean the filter.
Caution Messages
Use the list below to check the meaning of the messages displayed on the screen.
Message
Not applicable!
The panel keys are locked! "Panel Key Lock" on the INSTALL SETTING menu is set to "On."
44
Troubleshooting
Meaning and Remedy
Internal temperature is too high.
c When using the projector at an altitude of 1,500 m or higher, set
"High Altitude Mode" on the INSTALL SETTING menu to "On"
(see page 34).
c If this message appears on the screen when using the projector at
normal altitudes, check to see if anything is blocking the
ventilation holes (exhaust).
The internal temperature is too high.
c Turn off the power.
c Check to see that nothing is blocking the ventilation holes.
• This input signal cannot be projected as the frequency is out of the
acceptable range of the projector.
c Input a signal that is within the range of the frequency.
• The resolution setting of the output signal of the computer is too
high.
c Set the output setting to XGA (see page 14).
You have input an RGB signal from the computer when "Input-A
Signal Sel." on the SET SETTING menu is set to "Component."
c Set "Input-A Signal Sel." correctly (see page 30).
• It is time to replace the lamp.
c Replace the lamp (see page 37).
• If this message appears again after you replace the lamp, the lamp
replacement process is not complete.
c Perform the operations in step 8 and 9 on page 38.
• It is time to clean the filter.
c Clean the filter (see page 39).
c To erase a message, press any key on the control panel of the
projector or on the remote commander.
Meaning and Remedy
You have pressed the wrong key.
c Press the appropriate key.
c All the keys on the control panel of the projector are locked.
Operate the projector with the keys on the Remote Commander
(see page 31).