Sony VPL-CX86 Operating Instructions Manual page 22

Enter the password on this screen.
Enter new password key.
Power-on cannot be performed
without the password.
Use:
3
Enter the password again to confirm.
Re-enter new password key.
Be sure to remember this password.
Use:
When the following message is
displayed, the setting for security lock is
completed.
If "Invalid Password!" is displayed on
the menu screen, perform this procedure
again from step 1.
22
Security Lock
4
Security certification
Cancel: Other key
When the password screen is displayed,
enter the password that was set. If you fail to
enter the correct password after three tries,
the projector cannot be used. In this case,
press the ?/1 key to turn off the power.
To cancel the security lock
1
Cancel: Other key
2
If you call the customer service center because
you have forgotten the password, you will need
to be able to verify the projector's serial
number and your identity. (This process may
differ in other countries/regions.) Once your
identity has been confirmed, we will provide
you with the password.
Turn the main power off and
disconnect the AC power cord.
The security lock is set to on, then it
becomes effective. The screen used for
entering the password is displayed when
the power is turned on the next time.
Press the MENU key, then turn off the
" " setting on the
Security Lock
INSTALL SETTING menu.
Enter the password.
Enter the password that was set.
Note