Silvercrest SV 125 A1 Operating Instructions Manual page 54

Ensure that the power cable cannot be
trapped or crushed.
To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall
socket ...
... after every use,
... if there is a fault,
... when you are not using the device,
... before you clean the device and
... during thunderstorms.
DANGER - Fire hazard
Never leave the device unattended
while it is plugged in.
Use the device on a stable, level and
heat-resistant surface.
Never cover the device when connect-
ed due to possible overheating and fire
hazard!
Do not use the device in the vicinity of
flammable materials or flammable gas-
es.
DANGER! Risk of injury
through burning
The welding wire becomes very hot dur-
ing operation. Do not touch the hot
welding wire.
Allow the device to cool down com-
pletely before you clean it or put it
away.
DANGER! Risk of injury
Ensure that you never vacuum your skin,
hair or clothing with the adapters.
52 GB
DANGER caused by
insufficient hygiene
For a carefree enjoyment of your vacu-
um-sealed food, you should always
comply with the following hygiene tips:
- During the preparation and packag-
ing of the food make sure that the en-
tire equipment is perfectly clean.
- Clean the vacuum sealer and all de-
vices thoroughly after use.
- Perishable food should be cooled or
frozen immediately after sealing.
- After thawing or heating perishable
food, this must be consumed immedi-
ately.
WARNING! Risk of material damage
After the sealing and/or vacuuming
process, the device needs to cool down
for at least 80 seconds.
Only use special plastic film bags that
are suitable for use with vacuum sealers
/ bag sealers.
Never place the device on hot surfaces
(e.g. hot plates) or near to heat sources
or open fire.
Ensure that no liquid is sucked in during
the extraction of air.
The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have components that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
Do not use any sharp or abrasive clean-
ing agents.