Stop Watch; Setting The Am Reception Spacing - Silvercrest SWDR 500 B1 Operating Instructions And Safety Instructions

SilverCrest SWDR 500 B1
Please note: When the NAP-timer is activated do not press any
buttons apart from "SET/STORE" (9), "VOL-" (12) or "VOL+" (4).
Otherwise the NAP-timer will be finished.

Stop watch

To use the stop watch, proceed as follows:
 While the device is powered off, press the "MODE" button (15) three times.
The display (6) shows the stop watch icon (23) and "STOP" 00:00
(minutes:seconds) and in the upper right corner the seconds/100 are
shown.
 Press the "VOL+" button (4) briefly to start the stop watch.
 Press the "VOL+" button (4) briefly again to stop or pause the stopwatch.
 Press the "VOL+" button (4) again to resume the stopwatch from the currently
displayed time count.
 Press the "VOL-" button (12) briefly to stop reset stop watch to 00:00.
While the stop watch is running, the running time is shown on the
display (6). After resetting the stop watch to 00:00, the display
toggles to the normal clock time after approx. 8 seconds.

Setting the AM reception spacing

Due to different radio broadcasting band allocation in different countries it is
necessary to adjust the tuning spacing:
Region
Europe
America
The procedure is as follows:
 While powered off, press and hold the "SET/STORE" button (9) until the
display (6) reads "US" or "EU". Now press the "VOL-" (12) or "VOL+" (4)
26 - English
Frequency band
522 kHz - 1,620 kHz
520 kHz - 1,710 kHz
Tuning spacing
9 kHz
10 kHz