Appendix 2: Mounting Vhf Splitter - Furuno FA-30 Operator's Manual

Appendix 2: MOUNTING VHF SPLITTER

The VHF splitter enables the AIS receiver and VHF transceiver to share a single VHF antenna.
Note: The FA-30 can not receive AIS signal when the VHF transceiver is transmitting.
Equipment Lists
VHF Splitter: Type OP05-106, Code No. 000-011-704
No. Name
1 VHF Splitter Assembly
2 Installation Materials
Mounting procedure
1. Open the detachable cover.
View
2. Unfasten four screws to separate the
chassis from the mounting plate.
3. Disconnect plugs on J7, J12 and the
ground wire from pcb 05P0807 .
Type Code No.
OP05-106-1 001-024-100
CP05-11301 001-024-110
Side View
2. Unfasten
four
screws.
AP-2
Qty
1 Rear panel + pcb 05P0817
1 Cable tie CV-70N, 1 pc.
1. Put fingers on both sides and
pull outwards and lift up to
take off.
3. Disconnect.
Remarks
Ground wire