Furuno FA-30 Mounting Procedure
Vhf splitter
Hide thumbs
Also See for FA-30:
- Operator's manual (40 pages) ,
- Brochure & specs (6 pages) ,
- Setup, installation and troubleshooting tips (6 pages)
Advertisement
Quick Links
Download this manual
See also:
Operator's Manual
FA-30 VHF SPLITTER
MOUNTING PROCEDURE
The VHF splitter enables the AIS receiver and VHF transceiver to share a single VHF antenna.
Note: The FA-30 can not receive AIS signal when the VHF transceiver is transmitting.
Equipment Lists
VHF Splitter: Type OP05-106, Code No. 000-011-704
No.
Name
1
VHF Splitter Assembly
2
Installation Materials
Mounting procedure
1. Open the detachable cover.
View
2. Unfasten four screws to separate the
chassis from the mounting plate.
3. Disconnect plugs on J7, J12 and the
ground wire from pcb 05P0807 .
Type
Code No.
OP05-106-1
001-024-100
CP05-11301
001-024-110
Side View
2. Unfasten
four
screws.
www.furuno.co.jp
Qty
Remarks
1
Rear panel + pcb 05P0817
1
Cable tie CV-70N, 1 pc.
1. Put fingers on both sides and
pull outwards and lift up to
take off.
3. Disconnect.
Ground wire
Advertisement
Related Manuals for Furuno FA-30
Summary of Contents for Furuno FA-30
- Page 1 MOUNTING PROCEDURE The VHF splitter enables the AIS receiver and VHF transceiver to share a single VHF antenna. Note: The FA-30 can not receive AIS signal when the VHF transceiver is transmitting. Equipment Lists VHF Splitter: Type OP05-106, Code No. 000-011-704...
- Page 2 4. Turn over the chassis. Then, disconnect mini coaxial wire from J2 on pcb 05P0808A. 05P8080A Hole 4. Disconnect mini coaxial wire. Bottom view 5. Unfasten four screws from the rear panel to come free. 5. Unfasten four screws. Rear panel 6.
- Page 3 15.Connect the coaxial cable from the VHF antenna to the ANT port. 16.Connect the coaxial cable from the VHF transceiver to the VHF port. Note: The wrong connection of coaxial cable from VHF antenna or VHF transceiver may damage this equipment. VHF antenna FA-30 05P0808A 05P0187 05P0808B VHF transceiver...