Enabling The Alarm - Silvercrest SWE 100 B1 User Manual And Service Information

Multi-Band Tuner SWE 100 B1

Enabling the Alarm

After the desired alarm time has been set, you can enable the alarm as
follows:
 Press the AL.ON/OFF button [3]. The indication "ALARM" [30]
appears on the display.
 To disable the alarm, press the AL.ON/OFF button [3] again. The
indication "ALARM" [30] disappears.
 The device will power on at the set alarm time and will receive the last
tuned-in frequency and frequency band.
 Press the AL.ON/OFF button [3] to switch the device off. To disable
the alarm, press the AL.ON/OFF button [3] again.
 or
 Press the SNOOZE button [6] to delay the alarm for approx. 5
minutes. After this delay, the device will power on again.
20 - English
Even when the alarm function is enabled, you can use
the device as usual. However, remember that the device
always powers on with the last tuned-in frequency and
frequency band as well as the last volume setting.
The alarm function will work only if the device has been
powered off previously.