Projecting - Sony VPL-CS5 Operating Instructions Manual

Projecting

I / 1
FREEZE MS SLIDE
KEYSTONE
INPUT APA
MENU PIC ENTER
MUTING
1
Open the connector panel, plug the AC power cord into a wall outlet, then
connect all equipment.
The ON/STANDBY indicator lights in red and the projector goes into
standby mode.
2
Press the I /
The ON/STANDBY indicator lights in green and the Intelligent Auto-setup
starts. The lens protector opens, and the powered tilt adjuster rises and stops at
the previously adjusted position.
3
Turn on the equipment connected to the projector.
Depending on the type of your computer, for example a notebook, or an all-in-
one LCD type, you may have to switch the computer to output to the projector
by pressing certain keys (e.g.,
computer's settings.
Rear remote control
detector
ON/STANDBY
indicators
2
1 key.
LCD
7
6
TILT
, etc.), or by changing your
/ /
,
VGA
4
23
GB
Projecting