Changing Tools; Fitting The Sanding Sheet Onto The Sanding Plate - Parkside PDMFW 15 A1 Translation Of The Original Instructions

Application:
sanding up to edges and hard-to-reach areas .
Z85 D4
Segment saw blade Z85 D4
Material:
wood
Application:
–
separation and plunge saw cuts
–
sawing close to edges, even in hard-to-reach
areas
Example: working parquet and other flooring
materials, also with plunge cuts .
Scraper Z52 C3
Materials:
mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application:
–
removal of material residues, such as tile
adhesive, when replacing damaged tiles .
■ 10 │ GB │ IE │ NI

Changing tools

WARNING! RISK OF INJURY!
■ Always detach the tube from the compressor
before changing accessories .
■ Ensure that the appliance is no longer in
operation .
■ First, loosen the hex screw
together with the spring washer
use the supplied hex key
■ Remove the plain washer
■ Fit the tool (e .g . the plunge saw blade
the tool holder .
■ Replace the plain washer
place the spring washer
■ Screw in the hex screw
hex key .
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury .
NOTE
► You can fit the tools in any snap position on
the tool holder .
Fitting the sanding sheet onto the
sanding plate
Attachment:
♦ You can attach the sanding sheet
sanding plate using the Velcro .
and remove it
. To do this,
.
.
) onto
onto the tool and
on top of it .
using the supplied
to the
PDMFW 15 A1