Troubleshooting - Sony KP-44PX2U Instruction Manual

Here are some simple solutions to problems which may affect the picture and sound.
Problem
No picture (screen is dark) and no sound.
Poor or no picture (screen is dark), but
good sound.
No picture or no menu information from
equipment connected to the Scart
connector.
Good picture, no sound.
No colour on colour programmes.
When you switch on the TV the last
channel you were watching before
switching the TV off does not appear.
Undefined picture with different colour on
the outlines of the images.
Noisy picture when viewing a TV channel.
Distorted picture when changing
programmes or selecting teletext.
Wrong characters appear when viewing
NexTView.
Brightness level of the picture is
notoriously decreased when viewing a
teletext page.
Remote control does not function.
The standby indicator on the projection
TV flashes.
If you continue to experience problems, have your projection TV serviced by qualified personnel.
Never open the casing yourself.
26
Additional Information
Solution
• Check the aerial connection.
• Plug the TV in and press the
• If the standby indicator
• Using the menu system, select the "Picture Adjustment" menu and select "Reset"
to return to the factory settings.
• Check that the optional equipment is on and press the
the remote control until the correct input symbol is displayed on the screen.
• Press the + button on the remote control.
• Check that "TV Speakers" is "On" in the "Sound Adjustment" menu.
• Check that headphones are not connected.
• Using the menu system, select the "Picture Adjustment" menu and select
"Reset" to return to factory settings.
• This is not a malfunction. Press the number buttons on the remote control to
select the desired channel.
• Adjust the colour registration. For more details, please refer to "Adjusting Colour
Registration (Convergence)" section on page 10.
• Using the menu system, select the "Manual Programme Preset" menu and adjust
Fine Tuning (AFT) to obtain better picture reception.
• Using the menu system, select the "Noise Reduction" option in the "Picture
Adjustment" menu and select "Auto" to reduce the noise in the picture.
• Turn off any equipment connected to the Scart connector on the rear of the
projection TV.
• Use the menu system to enter the "Language" menu (see page 14) and select the
same language that NexTView is broadcast in.
• This is not a malfunction. After 5 minutes viewing the same teletext page and
without any button being pressed, the projection TV automatically decreases the
brightness level to avoid any damage to the picture tube. To reset the brightness
level, press any button of the remote control.
• Check that the Media Selector on the remote control is set to the device you are
using (VCR, TV or DVD).
• If the remote control does not operate the VCR or DVD even when the Media
Selector has been set correctly. Enter the necessary code set as explained in the
"Remote Control Configuration for VCR/DVD" chapter on page 23.
• Replace the batteries.
• Contact your nearest Sony service centre.
button on the front of the projection TV.
is on, press TV button on the remote control.
button repeatedly on