Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
Follow the steps below to program your TV's remote control to operate non-
Sony video equipment.
Find the three-digit code for your equipment from the "Manufacturer's
Codes" listed on page 27. If more than one code number is listed, try
entering from the code listed first.
1 Press and hold the
program on the remote control and press the
SAT/CABLE) will flash.
2 Enter the three-digit manufacturer's code number using the --9
buttons while the
within 10 seconds, you must start again from step 1.
3 Press the
button while the
When the programming is correct, the selected
blinks twice, and when not, blinks five times.
program any of your connected equipment using any one of the buttons
regardless of the label. For example,
operate your VCR. If you have a DVD/VCR combo that you want to
operate with your TV remote control, you can program with the
or even the
programmed for your particular use.
To check if the code works
Aim your TV's remote control at the equipment, and press the green
button. If you can turn the equipment on and off by using the remote control,
then the programming is complete. If not, try the next code listed.
If no code is input within the above specified time, or an invalid or
incorrect code number is input, the remote control automatically goes
back to the previous setting.
In some cases, you may not be able to program your remote control to
operate other equipment. In such cases, use the equipment's own
Programmable Code Number
101 (Sony Blu-ray Disc Player)
901 (Sony Dream System)
801 (Sony Satellite Receiver)
button (BD/DVD, DVR/VCR or
button is lit. If the code is not entered
buttons are labeled as such, you can still
button can be programmed to
, but remember which button you have
button you want to
button is lit.