Sony UP-D71XR Instructions For Use Manual page 18

2
Place the head cleaning sheet in the paper tray, and
insert the paper tray in the printer.
Head cleaning sheet
(Place this side up when loading.)
Paper fed direction
3
Press the MENU button.
4
Display the CLEANING item on the printer
window display by pressing the F or f button, then
press the g button.
The printer enters the cleaning mode.
5
Press the g button.
Cleaning is started. When cleaning has been
completed, the head cleaning sheet is ejected.
The printer returns to standby status.
6
Remove the paper tray again, place the roller
cleaning sheet in the paper tray, and re-insert the
paper tray.
Roller cleaning sheet
(Place this side up when loading.)
Hole
Paper fed direction
18
Precautions
Hole
Paper tray
Paper tray
7
Repeat steps 3, 4 and 5 to clean the roller.
8
Load the paper removed in step 1 and re-insert the
paper tray.
To clean the thermal head
If the printout quality deteriorates, for example, when
white strips still appear on the printouts, even after you
have cleaned the thermal head and roller using the
cleaning sheets, you should clean the thermal head using
the thermal head cleaning kit (supplied).
For detailed information on how to use the thermal head
cleaning kit, refer to the operating instructions supplied
with the thermal head cleaning kit.
1
Press the G, g, and STOP buttons simultaneously.
The thermal head is released.
2
Press the POWER switch to turn off the printer.
3
Remove the screw from the maintenance door
located on the left side panel and open the door.
4
Insert the cleaning tip holder until it stops, then pull
it toward you until the open window on the holder
fully appears.
Insert and pull out the holder about three times.
5
Remove the cleaning tip holder and close the
maintenance door.
6
Put the screw removed in step 3 back on the
maintenance door.
Note
Be sure to close the maintenance door and fasten it
with the screw. If the maintenance door is not
locked completely, the maintenance door may
open, and the printer stops the job while printing.
7
Press the POWER switch to turn on the printer
again.
Open window