Table of Contents
Advertisement
2 The stored image data is printed as soon as the
print command is entered from the computer or
the PRINT button of the printer is pressed.
Indicates that the printer is printing.
3 It takes about 45 seconds for a printout to
emerge from the paper outlet. However,
printing time depends on the size of the image.
Once printing has been completed, the printer
returns to standby status.
Notes
• While printing, do not remove the paper tray pressing
the EJECT TRAY button or do not open the
maintenance door.
• Do not pull the paper out until the printer finishes
printing.
• To prevent paper jamming, do not allow more than 10
printouts to remain on the paper cover.
To stop receiving data or to stop printing
midway
Press the STOP button. Or send the stop command from
the computer. Data reception is halted midway and the
printer is reset to standby status. When the printing job
is cancelled midway, the following message appears.
After the partially printed paper remaining in the printer
is ejected, the printer is reset to standby status.
Note
When a computer with the Windows operating system is
used, the computer may hang up if you press the STOP
button while transferring data. It is recommended that
you cancel printing from the computer side.
About memory
The image data sent from the computer is stored in the
memory of the printer. The data for one image to be
printed can be stored.
To reprint an image
Execute the print operation using the print menu of the
computer again or press the PRINT button of the printer.
The image data stored in the memory is printed again.
If the printer does not print
The printer will fail to print in the following cases:
• An error message is displayed in the printer window
display. Take remedies according to "Error Messages"
on page 20.
• When the printer is turned off, transferred image is
erased from memory, so there is nothing to print. Send
the image data to the printer again to print it.
Notes on storing your printouts
• Do not leave the printouts in direct sunlight or bright
room light. Store in a dark area at low temperature
(30°C (80°F) or lower) and low humidity. We
recommend storing the printouts in a polypropylene
pouch in a cabinet.
• Do not allow any volatile organic solvent such as
alcohol to come in contact with the printouts.
Adhesion to cellophane tape or PVC will cause fading
of the printout. Be careful when storing the printouts.
• Do not stack the printouts on or under a freshly
developed diazo copy sheet as this could cause the
film to turn black.
13
Printing
Advertisement
Table of Contents
