Advertisement
2. Remove the screws securing the awning fabric at
each end of the awning rail. See FIG. 1.
AWNING
RAIL
2 INCHES
#6 SELF
DRILLING
SCREW
ON SQUARE HARDWARE:
3. Place a 1/8" cardboard or wood spacer between the
arm and the rafter. Wrap gray tape around the arm
and rafter to hold them together. See FIG. 2.
Repeat on opposite end of awning.
FIG. 2
ROLLER TUBE
END CAP
4. Remove both of the patio feet from their mounting
brackets and extend the adjustable arms until each
patio foot rests on the ground. Tighten knob to
secure adjustable arm in this position.
FIG. 1
FABRIC
EDGE
"More information https://www.caravansplus.com.au"
5. To keep the awning from unwinding be sure the lock
lever is in the roll down position and a nail inserted
in each torsion assembly for positive locking of the
roller tube. The left end should be done first. Insert
pin into hole on the left end cap. Grasp roller
assembly and release Safe-T-Lock™ lever. Allow
awning to roll up slowly until it stops against the pin.
Insert the pin into the right end cap to hold it in place.
See FIG. 3.
FIG. 3
6. Remove the two #14 x 2" Hex Head screws from the
top mounting bracket. Repeat for the opposite end.
See FIG. 4.
FIG. 4
TOP MOUNTING BRACKET
#14 HEX.
HD . SCREW
PIVO T
AWNING RAIL
3
8300 and Sunchaser Service Instructions
TOP MOUNTING
BRACKET
#14 HEX.
PIVO T
HD . SCREW
AWNING
RAIL
Advertisement
