Komatsu PC300LC-8 Operation & Maintenance Manual page 181

MACHINE OPERATIONS AND CONTROLS
Adjusting Angle of Rear View Camera
Be sure to adjust the cameraes before starting work. If they are not adjusted properly, you cannot secure the visibility and may
be injured or may injure someone seriously.
When adjusting the angle of the camera over the counterweight, provide a secure scaffold using a step ladder and then carry
out the work. Do not do the work standing on the counterweight, as there is always the danger of a serious injury due to falling-
off from the machine.
If the image on the monitor is not aligned correctly, remove cover
(1) and adjust the mounting angle (A) of the rear view camera.
Amount of adjustment of angle (A): Within a range of 35°-80°
1. When removing cover (1), insert a flat-headed screwdriver into
the hole of cover (2), push the tooth on the inside, and remove
the cover.
2. Remove 2 bolts (3).
3. Remove cover (1).
3 - 126
WARNING
OPERATION