Fanimation Windpointe MW75 Series Manual page 8

Assembling and Mounting the Fan Blades and Switch Hsg
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
1. Remove and discard the (rubber) motor "stops" by
removing the five screws. (Figure 1)
2. Lay the side of the blade holder on a flat surface with
the inside of the blade holder facing up. Assemble the
blade to the blade holder with the carriage nuts, pan
head serrated screws and the blade cover. Make sure
the bottom edge of blade is full seated againsti the blade
holder. (Figure 2)
3. Attach assembled blades and blade holders to the motor
hub using the provided screws with lock washers.
Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated. (Figure 3)
4. Remove one of the three screws in the support bracket
at the bottom of the motor assembly and retain the screw
for later. Slightly loosen the remaining two screws.
(Figure 4)
Blade
Holder
HARDWARE USED:
3/16˝-24
Pan Head
Serrated Screw
3/16˝-24
Carriage
Head Nut
Screw
(2 per blade
holder)
HARDWARE USED:
1/4˝-20
Pan Head
Screw
8
Motor Stop
Figure 1
Blade
Cover
Figure 2
x 10
x 10
Figure 3
x 10
Motor
Assembly
Figure 4