Table of Contents
Advertisement
Ceiling fans must be installed by a licensed electrician.
To avoid possible re or shock, be sure electricity is
turned off at the main fuse box before wiring.
(Figure 1)
Securely connect the green/yellow earth wires from
1.
ceiling fan, hanger bracket and the supply green/yellow
earth wire to the terminal block as shown in Figure 2.
Securely connect the blue (Neutral) fan motor wire and
2.
the black supply (Neutral) to the "N" terminal of the connector
block as shown in Figure 2.
Securely connect the orange light wire (Light Active) and
3.
the red light wire (Light Active) to the "L" terminal of the
connector block. Securely connect the brown ( Motor Active)
fan motor wire and the red (Active) wire to the "L" terminal of
the connector block as shown in Figure 2.
After connections have been made, carefully push leads
4.
into the recess making sure there is separation between
connectors.
INSTALLATION NOTE: If light fixture is NOT required,
terminate the orange (Light Active) to terminal "L1".
Installing Wall Control (Rotary) Switch
With electrical power still disconnected, install fan
1.
switch control wiring to desired location on wall.
Ensure wiring connections are as shown in Fig 2. The
2.
Active (Red) supply wire must be connected
to terminal "C" on the rotary switch. Return switched wire
Fit the wall control (rotary) switch to a face plate (not
3.
supplied) and attach to wall.
INSTALLATION NOTE:The "O" and the small corner
cut-out on the front of the switch mechanism must be at
the top and top left respectively (See Figure 3).
IMPORTANT: Fan installation must be completed,
including the installation of the fan blades, before testing
of the controls.
Restore electrical power to the ceiling fan by turning
4.
the electricity on at the main fuse box.
Check the operation of the fan by rotating the control
5.
through the four positions marked 0 - III
("0" position is OFF) (Figure 4).
All fans are shipped from the factory with the reverse
6.
switch positioned to circulate air downward.
If airflow is desired in opposite direction, turn your fan
OFF and wait for the blades to stop turning,
then slide the reversing switch to the opposite position,
and turn fan on again.
How to Wire This Ceiling Fan
WARNING
Check to see that all connections are tight, including
earth, and that no bare wire is visible at the wire
connectors, except for the earth wire. Do not operate
fan until the blades are in place. Noise and motor damage
could result.
7
MAIN FUSE BOX
Figure 1
Figure 2
= OFF = FAST
= MED
Figure 3
Figure 4
WARNING
Advertisement
Table of Contents
