MJX R/C Bugs 4W User Manual page 10

Smart RTH
When the GPS signal is available( more than 7 satellites is presented), use the RTH
remote controller or tap the RTH button in the "Bugs Go" APP and follow the on-screen instructions to
initiate Smart RTH. During the smart RTH, you can use the remote controller to guide the aircraft
around obstacles. You can press the RTH button again to exit RTH procedure and regain control of
the aircraft.
Low Battery RTH
The low battery level failsafe is triggered when the MJX intelligent battery is depleted to a point
that may affect the safe return of the aircraft. Users are advised to return home or land the aircraft
immediately when prompted.
1. When the aircraft rear lights flash slowly, battery icon "
on the "Bugs Go" APP. And steady "beep beep beep... beep beep beep" sound is heard. At this
moment, the aircraft will automatically return to the Home Point if the flying altitude is beyond 50
meters or the flying distance against the home point is beyond 100 meters.
2. When the aircraft rear lights flash slowly, battery icon "
the "Bugs Go" APP. And steady "beep..beep...beep" sound is heard. At this moment, the aircraft will
automatically return to the Home Point if the flying altitude is beyond 15 meters or the flying distance
against the home point is beyond 15 meters. If the aircraft flying altitude is less than 15 meters or
the flying distance is less than 15 meters, the aircraft will automatically land to the ground.
Attention: When the aircraft is automatically return home with Low Battery RTH
!
function activated, you can not cancel the RTH procedure by pressing the
RTH button to regain control of the aircraft.
Failsafe RTH
If the Home Point was successfully recorded and the compass is functioning normally, Failsafe RTH
will be automatically activated if the remote controller signal is lost beyond 6 seconds. Return-to-Home
can be cancelled by the pilot, allowing them to regain control when the remote controller signal
connection is re-established.
" is shown on the remote controller or
" is shown on the remote controller or on
-8-
Bugs 4W User Manual
button on the