MJX R/C Bugs 4W User Manual page 19

Smart RTH button
● Press the button
fly back to the recorded Home Point.
● Press the RTH button again to exit RTH procedure and regain control of the aircraft.
● For more information about RTH, please turn to Return to Home section.
Low battery warning
● When the battery icon "
beep beep beep" sound, it means that the aircraft battery is nearly low voltage. At this time, the
aircraft front lights glow solid on and rear lights flash slowly. The aircraft will perform smart RTH
when the altitude is over 50m or the distance is over 100m.
● When the battery icon "
it means that the aircraft battery is in low voltage. At this time, the aircraft front lights glow solid on
and rear lights flash rapidly. The aircraft will return when the altitude is over 15m or the distance is
over 15m; if either the flying altitude or flying distance is less than 15m, the aircraft will land to the
ground.
Signal strength indicator
● Signal strength bar "
● When the strength bar "
controller is under signal connection status.
● There are 2 situations that the strength bar "
long beep sounds.
1) The distance between the aircraft and the remote controller is too far causing a weak signal.
2) The battery is removed after the aircraft connects to the remote controller.
to start the RTH, the remote controller makes a beep sound and the aircraft will
" is shown on the LCD screen (Pic. 1) with steady "beep beep beep...
" is shown on the LCD screen (Pic. 2) with steady "beep ...beep" sound,
Pic. 1
" shows the strength of the received signal. The more, the better.
" changes from weak to strong circularly, it means that the remote
" is less than 2 grids or no displaying with steady
-17-
Bugs 4W User Manual
Pic. 2