Woods ALITEC PS9 1.5MD Operator's Manual page 7

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
 Before cleaning, adjusting, lubricating, or ser-
vicing this unit, always follow this MANDATORY
SAFETY SHUTDOWN PROCEDURE:
• Move the skid steer loader propulsion control
lever to the "neutral" position.
• Shut off the attachment by shutting off the
auxiliary hydraulic output.
• Lower the loader lift arms completely and roll
the attachment forward so it is securely resting
on firm ground or the shop floor.
• Engage the loader park brake.
• Move the loader throttle to the slow idle posi-
tion, shut the engine off, and remove the igni-
tion key.
• Keep the key with you at all times when work-
ing on the unit so no one can start the engine
without your knowledge.
 NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equipment
or between moveable parts even when the engine
has been turned off. Hydraulic system leak-down,
hydraulic system failures, mechanical failures, or
movement of control levers can cause equipment
to drop or rotate unexpectedly and cause severe
injury or death.
• Service work does not require going under-
neath implement.
• Read Operator's Manual for service instruc-
tions or have service performed by a qualified
dealer.
 Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
 Your dealer can supply original equipment
hydraulic accessories and repair parts. Substitute
parts may not meet original equipment specifica-
tions and may be dangerous.
 Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
Alitec Pavement Saw (Rev. 3/2/2007)
SAFETY RULES
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
 Do not allow bystanders within 25 feet of the
area when operating, attaching, removing, assem-
bling, maintaining, or servicing equipment.
 Be sure attachment is properly secured,
adjusted, and in good operating condition. Coupler
lockpins must be fully extended and properly
engaged into attachment retaining slots.
 Never perform service or maintenance with
engine running.
 Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
 Tighten all bolts, nuts, and screws to torque
chart specifications. Check that all cotter pins are
installed securely to ensure equipment is in a safe
condition before putting unit into service.
 Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section for
location.)
 Make sure shields and guards are properly
installed and in good condition. Replace if damaged.
 Do not disconnect hydraulic lines until all sys-
tem pressure is relieved. Lower unit to ground,
stop engine, and operate all hydraulic control
levers.
STORAGE
 Follow manual instructions for storage.
 Keep children and bystanders away from stor-
age area.

SAFETY 7