Woods ALITEC PS9 1.5MD Operator's Manual page 15

PROBLEM
Cutting wheel rotates in the wrong
direction.
Hydraulic sideshift is not operating.
Oil leaking from sideshift cylinder.
Excessive vibration during cutting
operation.
MPS9 (Rev. 4/20/2007)
TROUBLESHOOTING
POSSIBLE CAUSE
Auxiliary hydraulics are being
activated in the wrong direction.
Quick disconnects are switched on
auxiliary hoses.
Diverter valve is set to the cutting
position.
Hoses to the sideshift cylinder are
obstructed.
One or more seals in the sideshift
cylinder have failed.
Obstruction between pivot frame and
side frame.
Insufficient hydraulic flow from skid
steer.
Air is trapped in the sideshift cylinder
hoses.
Cylinder rod is bent.
One or more seals on cylinder have
failed.
O-rings on fittings are damaged.
Fittings are loose or damaged.
Hydraulic hoses are loose or
damaged.
Picks are excessively worn.
Insufficient down force due to
incorrect operating procedure.
Pivot pins excessively worn.
Reverse direction of auxiliary flow.
Switch male and female auxiliary
QDs.
Make sure the diverter valve knob is
pulled outward as far as possible.
Remove and visually inspect hoses.
Contact dealer.
Remove obstruction.
Refer to skid steer owner's manual.
Remove hoses from cylinder,
activate sideshift function to
evacuate air and re-attach hoses.
Visually inspect cylinder for damage.
Contact dealer.
Visually inspect O-rings and replace
as needed.
Tighten or replace as needed.
Tighten or replace as needed.
Visually inspect picks and replace as
needed.
Refer to the "Operation" section.
Remove pins and inspect for wear.
Troubleshooting 15
SOLUTION