Lubrication - Woods ALITEC PS9 1.5MD Operator's Manual

PICK INSTALLATION
CAUTION
 Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
3. Insert the pick tool (1) into the slot on the pick (2)
as shown in Figure 22.
4. Drive the pick into holder by striking tool on circular
protrusion (3).
Figure 22.
NOTICE
Do not install pick by hitting the point of the
■
pick as this may cause damage to the pick and pre-
mature failure.
HOSES
NOTICE
Always make sure the hoses are not kinked or
■
pinched. These conditions can and will lead to pre-
mature wear and failure of a hydraulic hose.
Remove and inspect the hoses for these conditions
at regular intervals.
■ Never replace a hose with one that has a
lower pressure rating or one that has a smaller
diameter. Woods Equipment Company will not be
responsible for problems or warranty claims on
your pavement saw if the hydraulic system has
been altered from its original configuration.
Do not modify or alter or permit anyone else
■
to modify or alter the equipment or any of its com-
ponents in any way.
MPS9 (Rev. 4/20/2007)
LUBRICATION POINTS
All grease points should be serviced after 40 hours of
operation:
• Depth Jack (MD Only) (4)
• Front and rear wheels (4)
• Depth skid pivot (3)
• Shroud pivot pin (4)
•
Pivot frame slider tubes (2)
Figure 23. Depth Jack
Figure 24. Rear Wheels
Service 19