Depth Jack; Pick - Woods ALITEC PS9 1.5MD Operator's Manual

Figure 17.
DEPTH JACK (MD, MANUAL DEPTH) OR
DEPTH CYLINDER (HD, HYDRAULIC
DEPTH)
REMOVAL
NOTICE
Make sure the front wheels of the pavement
■
saw are not supporting the attachment. The skid
steer motor needs to be off with no residual pres-
sure in the hydraulic lines of the cylinder before
proceeding any further.
1. (HD Only) Remove hoses from the cylinder (9) as
shown in Figure 18. Install caps to the fittings of the
cylinder and the hoses to prevent contamination
and spillage.
Figure 18.
2. (MD Only) Remove the snap rings (10) and pins
(11) as shown in Figure 19.
3. Install the depth or hydraulic cylinder using the
reverse procedure of Step 1 or Step 2.
18 Service
Figure 19.
PICK REMOVAL
A
WARNING
 Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
1. Insert the pick removal tool (1) into the slot on pick
(2) as shown in Figure 20.
Figure 20.
2. Hit the pick removal tool on the round protrusion to
drive the pick out as shown in Figure 21.
Figure 21.
MPS9 (Rev. 4/20/2007)