Let’s Talk Technical; Resetting/Removing Debris From The Brushbar; Changing The Brushbar/Advanced Brushbar Cleaning - Vax Air Lift Steerable UCPESHV1 Let's Get Started

Let's talk technical
IMPORTANT: Unplug and switch off vacuum cleaner before performing maintenance or troubleshooting checks.
If the brushbar has been obstructed, the brush bar motor protection sensor may have been activated. The brushbar
will stop and the light on the floorhead will illuminate red.

Resetting/removing debris from the brushbar

The brushbar indicator
light will illuminate red
and the brushbar will stop
spinning if the brushbar is
obstructed.
Press the On/Off button
to switch the vacuum
cleaner on.

Changing the brushbar/advanced brushbar cleaning

Using a crosshead
screwdriver, remove 3
screws from the belt cover
on the side of the floorhead.
Press the On/Off button
to switch the vacuum
cleaner off. Unplug from the
mains.
Press the brushbar button
to activate the brushbar.
Pull to remove the belt
cover and brushbar
location plate. Remove belt.
Lie the vacuum cleaner on
its back. Using a pair of
scissors remove any threads
or hair caught around the
brushbar.
Lift and separate brushbar
side cover.
Plug in to the mains and
recline.
Pull brushbar through side
cover to remove. Using a
pair of scissors remove
any threads or hair caught
around the brushbar
before refitting.