Safety - SWR ENGINEERING Envea FlowJam A Operating Instructions Manual

2. Safety

The sensor FlowJam A was designed, built and tested to be safe and was shipped in safe condition.
Nevertheless persons or objects may be endangered by components of the system if these are operated in an
inexpert manner. Therefore the operational instructions must be read completely and the safety notes must be
followed.
In case of inexpert or irregular use, the manufacturer will refuse any liability or guarantee.
2.1 Regular use
Only original spare parts and accessories of envea™ SWR engineering Messtechnik GmbH must be
•
used.
2.2 Identification of dangers
Possible dangers when using the sensor are marked in the operating instructions.
•
2.3 Operational safety
The sensor must be installed by trained and authorised personnel only.
•
Switch off the power supply for all maintenance, cleaning or inspection works on the tubes or on
•
components of the FlowJam A.
Before hot work the sensor must be removed from the installation place.
•
The components and electrical connections must be checked for damages regularly. If a damage is
•
found, it is to be repaired before further operation of the instruments.
2.4 Technical progress
The manufacturer reserves the right to adapt technical data to the technical progress without particular
•
advance notice. If you have any questions, envea™ SWR engineering Messtechnik GmbH will be pleased
to inform you on possible changes and extensions of the operating instructions.
4