Table of Contents
Advertisement
5.8.1 Mounting
1.
Move housing over cable
2.
Prepare conductor
3.
Insert prepared conductors (with screw
connections: tighten screws, torque 2 Nm
(17.7 lbf-in) )
4.
Insert contact insert into housing(note)
5.
Turn contact insert until arrested.
6.
Lock contact insert.
7.
Tighten cable gland, torque
M32 gland: 12 Nm (106 lbf-in)
M40 gland: 14 Nm (124 lbf-in)
8.
Plug in RST connector
9.
Fasten bayonet
NOTE
Due to cold ow, extreme temperatures or temperature
variations may have a detrimental e ect on the strain relief.
NOTE on Releasing Crimp Connections
a.
Insert screwdriver (see detail)
b.
Open latch by screwdriver
c.
Take out cable
5. Electrical Connections
49
Advertisement
Table of Contents
