Table of Contents
Advertisement
4.1.1 Possible locations for installation
Selecting an optimal installation location for the ESS is required for operation safety,
e ciency and life of the product.
1.
This IP54 product is recommended to be installed indoor. If it is required to be installed
outdoor, the place must have a roof to avoid direct sunlight, rain and snow.
2.
Install the product in a well ventilated and clean area with no dust or insects.
(e.g. stockyards and carpets are not allowed).
3.
Do not install the product in an area prone to oods or a high humidity area.
4.
Do not install the product where a re or explosion might occur.
5.
Install the product in a place that is not exposed to corrosive gases (e.g. ammonia, acid,
salinity content, etc.).
6.
Install the product in a place where children cannot reach.
7.
Install the product considering the noise level because noise is generated during
operation, which may cause discomfort. (e.g. near a bedroom)
8.
The oor must be hard so that it can withstand the weight and vibration of the product.
(e.g. concrete structure)
9.
The oor must not be sloped or recessed where a pool of water may form. If this is an
issue, adjust the height of the oor to be at a higher point.
10.
The oor surface must be xed with anchors.
11.
Do not install the product on ammable material. Flammable materials must not be
placed within a speci c distance.
12.
Objects must not be stacked on top of the product.
13.
After connecting all the cables, make sure that they are rmly inserted.
4.1.2 Storing the ESS system
1.
The product must not be tilted when being moved. It must be lifted vertically.
2.
The product must not fall from a height of 10 cm or more.
3.
Make sure the product does not get wet in the rain or snow.
4.
Do not stack the products on top of each other.
4. Installation
17
Advertisement
Table of Contents
