Machine Care - Bissell 5288 SERIES User Manual

O
perations (Continued)
4. Check the filter frequently. If you see hair
and fuzzy debris collecting on the filter,
remove the dirty tank and dirty tank lid to
clean the filter.
5. To clean the filter, gently tap it on the edge
of the trash can, brushing off anything that
may be sticking to the filter. The filter can
also be rinsed with warm water. Let air dry
before inserting back into the unit.
Switching from dry vac to wet mop
1. To change from dry vacuuming to wet
cleaning, simply flip the unit around!
Wet Mop
1. Depress the spray trigger. Water and formula
will flow to the two spray tips on the wet
mop side.
NOTE: Depressing the spray trigger will turn
off the vacuum suction.
2. Gently mop the floor with the MicroFiber
pad. Dirty or sticky areas may require more
water and formula.
3. Allow 3-5 minutes for the floor to air dry.
M
aintenance and care

Machine care

1. Turn power switch "
2. After wet mopping is complete, remove the
MicroFiber pad from the unit.
NOTE: Check the clean tank. If a significant
amount of water and formula remains, you
may leave it in the clean tank for your next
cleaning task
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
ug603-6913_5288E_1006.indd 7 ug603-6913_5288E_1006.indd 7
4
1
1a
O
" (OFF).
Tip:
When the spray
trigger is squeezed
the vacuum suction
will stop; extending
usage time.
Tip:
Spray Tips
You do not have
to empty the dirty
tank before wet
mopping.
10/25/06 3:49:09 PM 10/25/06 3:49:09 PM
16 7