Basic Menu Operations - Sony UP-D897 Instructions For Use Manual

Item Function
b)
RSIZE To select whether
or not the image
is enlarged
SAVE To register up to
three kinds of
settings
b)
SHARP To adjust the
sharpness of the
printout
c)
SIDE To select the
direction in which
the image is to be
printed
SPEED To select the
(When printing speed
"ME:HD" is
selected in
"MEDIA,"
the printing
speed is fixed
to "SP:NOR"
and this item
is not
displayed.)
BACK To exit menu
mode
Settings
[RS:OFF]: Prints the image
at the original size.
RS:ON: Prints the image at
a larger size, according to
the paper size set by the
printer driver.
BACK: Cancels the setting
change and returns to the
item selection column.
SA:3: Registers the menu
settings as No.3.
SA:2: Registers the menu
settings as No.2.
[SA:1]: Registers the menu
settings as No.1.
BACK: Cancels the setting
change and returns to the
item selection column.
You can set the sharpness to
any of 15 steps, from 0 to
14.
At a setting of 0, the outline
of the printout is not
emphasized.
A setting of step 2 is the
factory setting.
BACK: Cancels the setting
change and returns to the
item selection column.
S:SIDE: Prints the image
rotated by 90 degrees
counterclockwise.
[S:STD]: Prints the image in
the same direction as that
displayed on the monitor.
BACK: Cancels the setting
change and returns to the
item selection column.
SP:NOR: Prints at the
normal speed.
[SP:HI]: Prints at high
speed.
BACK: Cancels the setting
change and returns to the
item selection column.
Note
When "SP:HI" is selected,
the power consumption is a
little higher, compared with
printing at the normal
speed.
Display this item and then
press the jog dial. The unit
exits the menu mode and
"READY" is displayed on
the LCD.
a) The printing direction is as follows.
When DI:NOR is selected
b) These items can also be set on the printer driver side.
When you place a check mark in a checkbox on the
"Settings" tab of the printer driver, the settings made
on the printer side are enabled. When "CO:895" is
selected in "COMD," these items are not displayed
and can not be set. When "CO:897" is selected, these
items are disabled since the computer sends the print
command to the printer until the printer completes
printing.
c) The print direction of the images printed is as follows.
Image displayed on the monitor
Printouts
When S:STD is selected.

Basic Menu Operations

This section describes the basic menu operation which
are common to each menu, taking "How to set the
printing direction" as an example.
1
Press the power ON/OFF switch to ON to turn the
unit on.
Adjustments and Settings Using the Menu
When DI: REV is selected
When S:SIDE is selected
11