Streaming Video Over Ip/Ethernet; Using The Mlr To Receive User Data; Maintenance Information - RF Central MICROLITE User Manual

MicroLite Receiver User Manual
Use the Remote Control Interface and/or the Web GUI interface to verify the status of
the MLR.
Use a video monitor to view SD Composite video (NTSC or PAL, as appropriate).
Display video on equipment with ASI or SDI input connectors. This may include video
analysis equipment or PC's with ASI or SDI input cards used for video storage and
editing.
To stream video over IP use the Ethernet connection to a PC or laptop running a
compatible MPEG4 audio and video decoder program.
Note: When operating in low latency, external MPEG4 software/hardware decoders
may not work.

5.6 Streaming Video over IP/Ethernet

The MLR is pre-configured to stream video over IP on its Ethernet port. To stream video over
IP use the Ethernet connection to a PC or laptop running a compatible MPEG4 audio and video
decoder program.
.

5.7 Using the MLR to Receive User Data

View User Data by using a laptop PC with a Terminal program. The User Data is through the
RS-232 (DB-9) connector. Refer to Table 2-1 for pin-out. Contact IMT for details.

5.8 Maintenance Information

Follow these procedures when maintaining the device:
Dry the device immediately if it comes into contact with water or other liquids. Warranty
does not cover liquid damage.
Do not submerge the device or use it directly in rain.
Do not open the device. This voids the warranty.
Keep the device clean by wiping with a soft, dry cloth. If necessary, dampen only using a
solution suitable for cleaning electronic devices. Warranty does not cover cleaning
damage.
Revision 1.1
27