Table of Contents
Advertisement
MicroLite Receiver User Manual
4.4 Connect External Signals
The microLite Receiver has the following major output interfaces:
Power Interface
RS-232 Serial Port
Left and Right Audio Outputs
Composite Video Output (not down converted from HD)
ASI Video Output
SDI Output for HD-SDI and SD-SDI Video
User Data
4.4.1 Audio and Video
Connect the desired Audio and Video outputs to A/V monitoring devices with
appropriate cables. The MLR has RCA jacks for audio and 75ohm BNC connectors for
Composite Video, SDI and ASI.
4.4.2 Power
Connect an appropriate DC power source to the DC in connector. The power source
requirements are listed in Chapter 3, Specifications. Power supplies and cables are
supplied with the unit.
4.4.3 RS232 Control and User Data
If desired, connect a suitable cable to the 9 pin D Remote/User Data connector per the
pinout below. Cables are available from IMT.
Pin
1
2
3
4
5
6
7
8
9
4.4.4 ASI Out
If required, connect a suitable ASI output cable (75Ω BNC).
Revision 1.1
Table 4-2: Remote Control / User Data Pinout
Function
N/C
RX / IN A
TX / OUT A
N/C
Ground
TX / OUT B
RX / IN B
N/C
N/C
Notes
Remote Control
Remote Control
Ground
User Data
User Data
22
Advertisement
Table of Contents
