Jenn-Air W11325607A Use & Care Manual page 8

Water Hardness
NOTE: The water hardness level is factory set at level 4. The
coffee system can be programmed according to the hardness of
your fresh water so the coffee system can be descaled less.
1. Remove the "Total hardness test" indicator paper provided
from the packaging.
2. Immerse the paper completely in a glass of fresh water for
about a second.
3. Remove the paper and shake lightly. After a minute, 1, 2, 3, or
4 squares will form. Each square corresponds to one level.
4. Press to enter the menu. Press
shows WATER HARDNESS.
5. To change the level selected, press the symbol itself until the
required level is displayed (Level 1 = soft water, Level 4 = very
hard water). Press
Auto-Off
Auto-off can be set so the coffee system turns off after 15 or 30
minutes, as well as 1-3 hours of no use.
1. Press
to enter the menu.
2. Press
or until the display shows
with the current selection (15 or 30 minutes, 1, 2 or 3 hours).
3. Press to select the required value; then press
return to the homepage.
Coffee Temperature
1. Press to enter the menu.
2. Press or until the display shows
TEMPERATURE together with the current selection (LOW,
MEDIUM, HIGH, or MAX).
3. Press
to select the required temperature.
4. Press to return to the home page.
ESC
*Water filter not available on this model.
8
04-Mar-2019 07:49:57 EST | RELEASED
or until the display
to return to the home page.
ESC
AUTO-OFF together
COFFEE
In some European factories the letter "W" of the part code mentioned herein will be automatically
Descaling
IMPORTANT: Before using, read the instructions and labels on
the descaler packaging.
Descale the appliance when the display shows DESCALING
NEEDED PRESS OK TO START (~45 min)
immediately, press
1. "REMOVE WATER FILTER" will show on the display (if
present). Remove the water filter (if present) and empty the
water tank. Press
2. ADD DESCALER (UP TO LEVEL A) AND FRESH WATER (UP
TO LEVEL B): Pour the descaler into the tank up to level A
marked inside the water tank. This is equal to one 100 mL
packet. Add 1 L (1 qt) fresh water up to level B and replace
tank. Press
to
ESC
3. EMPTY GROUND CONTAINER AND DRIP TRAY: Remove,
empty and replace drip tray and the grounds container.
4. PLACE 2.5 L (3 qt) CONTAINER UNDER OUTLET, PRESS OK
TO START DESCALING: Place an empty 2.5 L (3 qt) or larger
container under the hot water/steam spout and coffee spout.
OK
5. Press
added. The display will show DESCALING PLEASE WAIT,
which means the program has been started.
6. Descaler will come out of the hot water/steam and coffee
spouts. A series of rinses and pauses is automatically carried
out to remove all scale residue from the inside the coffee
maker.
7. After approx. 25 minutes, descaling will stop; RINSE AND
FILL WATER TANK UP TO MAX LEVEL will display. Empty the
container used for descaler solution and place back under the
spouts. Remove water tank, empty, rinse and refill to the MAX
level and replace tank. Press
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
OK and follow the steps.
.
NEXT
NEXT .
A. Water tank
to confirm that descaling solution has been
OK .
. To descale
A