Selecting The Coffee Size; Adjusting The Coffee Mill - Jenn-Air W11325607A Use & Care Manual

NOTE: It is possible to prepare two cups of espresso coffee at
the same time.
1. Press
2 during preparation of one espresso.
2. While the machine is making coffee, delivery can be
interrupted at any time by pressing
3. As soon as delivery has ended, to increase the quantity of
coffee in the cup, press
reached, press
STOP
4. Once the coffee has been made, the appliance is ready to
make the next beverage.
NOTE: Various messages may be displayed while using the
appliance (FILL TANK, EMPTY GROUNDS CONTAINER, etc.).
Their meanings are explained in section "Displayed messages."
For hotter coffee, see "Tips for Hotter Coffee" section.
■
If the coffee comes out in drops, too weak and not creamy
■
enough or too cold, see the "Adjusting the Coffee Mill" and
"Troubleshooting" sections.
If "Energy Saving" mode is active, the first coffee may take a
■
few seconds before it is delivered.
To Clean:
After every 14 cups of coffee made, the drip tray needs to be
cleaned and the coffee grounds container emptied.
1. Open the service door on the front by pulling the coffee spout.
2. Remove the drip tray and clean it.
NOTE: When cleaning the coffee system, always fully remove
the drip tray.
A. Coffee grounds container
B. Drip tray
3. Empty the coffee grounds container and replace it.
NOTE: Every time the drip tray is removed, the coffee grounds
container must be emptied. Failure to do so may clog the
coffee system.
4. Replace the drip tray and close the service door.
04-Mar-2019 07:49:57 EST | RELEASED
.
STOP
. Once the desired quantity is
EXTRA
.
A
B
In some European factories the letter "W" of the part code mentioned herein will be automatically

Selecting the Coffee Size

From the home page, select the required size of coffee in the cup
by pressing SIZE.
MY
MY
MY
MY
MY
After delivering the beverage, the size setting is reset to the
value.
MY

Adjusting the Coffee Mill

The coffee mill is factory-set and should not require adjustment.
However, if after making the first few coffees you find that the
coffee is either too weak and not creamy enough, or delivery is
too slow (a drop at a time), this can be corrected by adjusting the
grinding adjustment dial.
A
A. Grinding coarseness adjustment knob
NOTE: The grinding adjustment dial must only be turned when
the coffee mill is in operation during the initial phase of coffee
preparation.
1. If the coffee comes out too slowly or does not come out at
all, a message will be shown GROUND TOO FINE. ADJUST
GRIND LEVEL, turn the coffee mill dial one or two clicks
clockwise.
2. For fuller bodied creamier coffee, turn one click counter-
clockwise towards one. (Do not turn more than one click at a
time. Otherwise the coffee could come out one drop at a
time.)
A. Counterclockwise for finer grind
B. Clockwise for coarser grind
The effect of these adjustments will only be evident after at least
two cups of coffee have been delivered. If this adjustment does
not obtain the desired result, repeat the correction by turning the
dial another click.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
SMALL SIZE
MEDIUM SIZE
LARGE SIZE
EXTRA LARGE SIZE
CUSTOM SIZE (if programmed) /
STANDARD SIZE
A
B
11