Recalling Memory; How To Prevent A Malfunction; Maintenance And Repair - Bioland 2006-2B User Manual

Recalling memory

1. Press "M" button to turn on the device, then press "M" button until enter
memory state like right figure.
2. Press "M" or "S" button to check the next measurement data.
3. If there is no memory, it will display "—" and then turn off in one second.

How to prevent a malfunction

1. Do not drop the device and avoid sudden jars or shocks.
2. Do not inset other objects into any holes.
3. Do not attempt to disassemble the unit.
4. Do not crush the pressure cuff.
5. If the unit has been stored at temperatures below 0
30 minutes before using it, otherwise, may get wrong measurement result.
C, leave it in a warm place for
o
Page 9 of 14

Maintenance and repair

1. Do not wash or immerse the unit in water, use a soft and
dry cloth to clean it.
2. Do not use the volatile liquids to clean the main unit or
cuff.
3. Do not moisten the cuff, wash hands before measurement.
4. When the cuff dirty, Wipe on the surface of the cuff with a
cloth moistened with a 70% dilution of isopropyl alcohol or a
80% or less dilution of disinfection ethanol (ethyl alcohol).
Do not allow any liquids inside the cuff. If a liquid gets in the
cuff, dry the inside well.
5. Precision components are used in the construction of this
device. Extremes in temperature, humidity, direct sunlight,
shock or dust should be avoided.
6. The disassemble arm cuff can be store in the storage box.
7. When the unit is on, press the "S" and "M" buttons together for 5 seconds, when
"tst" displays, loose both buttons, the main program version will appear then enter
to the static pressure testing mode, and "DIA" location shows "00". (Only
professional technician is qualified to operate).
Note:
Do not maintain the equipment while it is in use
.