Install Or Replace Batteries; How To Use The Upper Arm Cuff - Bioland 2006-2B User Manual

Install or replace batteries

When the battery symbol appears on the display or nothing is display while inflation
during measurement, you should replace with new batteries.
1. Press the snap hook on the battery cover to open it.
2. Insert four "AA" batteries in the correct polarity direction.
3. Replace the battery cover.
4. With the use of four alkaline "AA" batteries, you can measure approximately 250
times at room temperature of 22℃ and inflating to around 170 mmHg once a day.
But the included batteries only for test purpose may not last as specified long period.
5. When the battery icon " " displays on the LCD, please replace four new
batteries, please do not mix the new and old battery together.
6. If the unit will not be used for a long period, please take out all batteries to avoid
liquid leakage damaging the unit.
Environment Protection – Waste electrical products should not disposed of with
household waste. Please recycle where facilities exist. Check with your local
authority or retailer for recycling advice.

How to use the upper arm cuff

1. Pass the end of the cuff (with sewn-in rubber
stopper) through the metal stirrup so that a loop is
formed. The Velcro closer must be facing outwards.
(Ignore this step if the cuff has already been prepared.)
2. Push the cuff over the left upper arm so that the tube
points in the direction of the lower arm and palm.
3. Lay the cuff on the arm as illustrated. Make certain
that the lower edge of the cuff lies approximately 1 to
2 cm (3/4~1") above the elbow and that the rubber
tube leaves the cuff on the inner side of the arm.
Page 6 of 14