Main Unit; Insert Or Replace Batteries; Time And Date Of System Setup; How To Use The Upper Arm Cuff - Bioland 2005 Instruction Manual

MAIN UNIT

1. Air Tube Hole
2. Blood pressure Display
3. Date and Time Display
4. Systolic Value
5. Diastolic Value
6. Pulse/min Value

INSERT OR REPLACE BATTERIES

During the battery symbol appears on the display or nothing is display while inflation during
measurement, you should replace with new batteries.
1. Slide the battery cover in the direction of the arrow to open.
2. Insert four "AA" alkaline batteries in the correct polarity direction.
Disposal of empty battery to the authorized
collecting party subject to the regulation of
each individual territory.
3. Replace the battery cover.
4. With the use of four alkaline "AA" batteries, you can measure approximately 250 times
at room temperature of 22 C and inflating to around 170mmHg once a day. But the
O
included batteries only for test purpose may not last as specified long period.
7. POWER Button
8. START Button
9. Button (UP) For memory recall and
Date / Time adjust
10. Button (DOWN) For memory
recall and Date / Time adjust
11. SET Button
12. Upper Arm Cuff
13. Air Tube
Four "AA" alkaline batteries
-7-
5. When the battery icon displays on the LCD, please replace four new alkaline "AA"
batteries, please do not mix the new and old battery together.
6. If the unit will not be used for a long period, please take out all batteries to avoid liquid
leakage damaging the unit.
SYMBOLS ON DISPLAY
MONTH/DATE
SYSTOLIC
SYS
MEMORY
DIASTOLIC
DIA
INFLATION
DEFLATION
LOW BATTERY
ATTENTION OF ERROR
HEART BEAT

TIME AND DATE OF SYSTEM SETUP

1. Press "POWER" key to turn on.
2. Press and hold "SET" key until the year number displays and flashes on LCD to enter
setting mode.
3. Press" " or " " key to adjust the year, then press " SET " key
again to save your setting and enter the
month setting mode.
4. Press " " or " " key to adjust the month.
Following the same steps to adjust date/hour/
minute until setting completed.
Note: Please check and re-set Date/Time after
replacing of new batteries.

HOW TO USE THE UPPER ARM CUFF

1. Pass the end of the cuff (with sewn-in rubber
stopper) through the metal stirrup so that a
loop is formed. The Velcro closer must be
facing outwards. (Ignore this step if the cuff
has already been setup.)
2. Push the cuff over the left upper arm so that
the tube points in the direction of the lower
arm and palm.
HOUR/MINUTE
VALUE OF SYSTOLIC
VALUE OF DIASTOLIC
UNIT OF PRESSURE
Kpa mmHg
PULSE
-min
VALUE OF PULSE PER MINUTE
PULSE UNIT
SYS
DIA
PULSE
-min
-8-