Yamaha Clavinova CVP-809 Owner's Manual page 115

5
Install the pedal box.
1 Remove the twist tie and tape that affix the pedal cord to
the upper portion of the pedal box.
.
Tape
2 Attach the front side of the pedal box to the bottom of the
unit by finger-tightening the two fixing screws (6 x 20 mm).
3 Insert the lyre braces into the pedal box recesses and make
sure they fit securely.
4 Align the cord with the groove on the unit and attach the
backside of the pedal box using the two fixing screws (6 x
20 mm), and then securely tighten the two screws of the
front side of the pedal box that were attached in step 5-2.
5 Loosen the four screws that were attached in step 3, and
then securely tighten the four screws again while pushing
Twist tie
the lyre braces in the direction of arrows as illustrated.
6 x 20 mm
fixing screws
6 Insert the pedal cord plug into the pedal connector. Insert
the plug so the arrow side faces front (toward the
keyboard).
If the plug will not go in easily, do not force it. Double-
check the orientation of the plug, then try again.
6
7
7 Attach the cord holder to the bottom of the main unit as
shown, then clip the holder around the cord.
6 x 20 mm fixing screws
Insert the pedal
cord securely
until the metal
part of the cord
plug disappears
from view.
Otherwise, the
pedal may not
function properly.
CVP-809/CVP-805 Owner's Manual
115