T+A Cala D User Manual page 36

The Configuration for a WLAN connection
Setting the Parameters for a
Radio Network
Searching for and Selecting
the Network
Entering the Password
(for encoded networks)
36
 Connect the WLAN aerial (supplied) to the  WLAN aerial socket, and
ensure that no cable is attached to the  LAN socket.
 Switch the  on, and select the Streaming Client function by pressing the
 button.
 Now call up the Configuration menu as described above: with a long press on
the  button. You should now see the menu reproduced below, dis-
playing the network parameters.
First select the menu point 'WLAN configuration start', and activate it by
pressing the  button.
A menu appears showing these points:
 Rescan
- initiates new search for accessible radio networks
 Set manually - adding a WLAN manually
After a brief delay the networks present in the vicinity are listed on the screen.
You can use the 'Rescan' function to start a new search for networks present in
the vicinity.
Please select one of the networks located, and activate it by pressing the
 button.
If your network is encoded, the window illustrated above now appears. Please
enter the network password and confirm the entry by pressing . Now
select the point 'Save WLAN settings' and confirm with .

If a WEP code is used, the password must be entered as a hexadecimal code
(0 - 9, A - F).
Please enter the settings for the remaining network parameters as described
earlier in the section entitled 'Setting the Parameters for a Wired Network'.
Possible entries